New digital oscilloscope Rigol DS70000 series
Rigol Technologies introduces the DS70000 series, a high-end multifunctional oscilloscope with up to 5 GHz bandwidth. The DS70000 series oscilloscopes are based on the UltraVision III architecture, providing higher sampling rates, increased memory depth, faster waveform acquisition, and better vertical resolution than previous models.
DS70000 Series Oscilloscope Specifications
- Maximum sample rate, 2 channels - 20 GS/s
- Number of input analog channels - 4
- Bandwidth - 3 GHz and 5 GHz
- Maximum memory depth, 2 channels - 2 Gsamples
- Signal update rate - 1000000 osc. / s
- Vertical resolution - 8 bits to 16 bits
- Real Time Spectrum Analysis (RTSA)
- 15.6-inch tilt-adjustable touch screen
- Diagonal of the additional display - 3.5 inches
A real-time eye diagram and jitter measurement software application will allow you to analyze the signal quality of high-grade interfaces.
A set of software options for triggering and decoding serial protocols supported by the DS70000 Series oscilloscope:
- RS232/UART, I2C, SPI
- CAN, LIN, FlexRay, CAN-FD
- I2S
- MILSTD-1553, ARINC 429
The DS70000 Series oscilloscope is equipped with a software application that allows you to pre-test devices for compliance with USB2.0 (Low/Full/High), 100Base-T standards. Later tests for 10/1000Base-T, MIPI D-PHY, Automotive Ethernet standards will be added.
A unique feature of the DS70000 Series oscilloscopes is the real-time spectrum analysis (RTSA) feature with an analysis bandwidth equal to the oscilloscope's bandwidth.
Using NFP-3 near-field probes in RTSA mode, you can identify sources of interference in your device under test.
Characteristics of Differential Probes Used with the DS70000 Series Oscilloscope
| Parameter | PVA8350 | PVA800 |
|---|---|---|
| Bandwidth | 3.5 GHz | 7 GHz |
| Input impedance | 50 kOhm / 0.6 pF | 50 kOhm / 0.6 pF |
| Attenuation factor | ten | ten |
| Maximum input voltage | ±10V | ±10V |
| Bias voltage | ± 6.25V | ± 6.25 V |
| Common mode rejection ratio | 40 dB | 40 dB |
| Probe noise floor | 3 mV rms | 3 mV rms |
For all questions related to the purchase of Rigol equipment, please contact the sales department by e-mail: sales@chipdip.ru or by phone +7 495 544-00-08 .