Fluke 773, Multimeter-calibrator with clamps for measuring low currents (State Register of the Russian Federation)

Extend the capabilities of the popular 771 Series Clamp Meters with the 772 and 773 Series.
All you have to do is decide which model best suits your needs.

Fluke 771, 772, and 773 Series Specifications:
• Best in class 0.2% accuracy
• Resolution and sensitivity - about 0.01 mA
• Measurement of a signal from 4 to 20 mA without breaking the current loop!
• Measurement of signals with low currents on PLC outputs and analog inputs/outputs of the control system
• Dual backlit display showing current measurement both in mA and as a percentage of the 4-20 mA range
• Built-in lamp for point illumination of conductors in places where external light does not penetrate
• Separate clamp with extension cable for measurements in hard-to-reach places
• Measurement of 10-50 mA signals in older control systems using the 99.9 mA range.
• Automatic change of 4-20 mA signal for remote testing
• Energy saving settings, auto power off, timed backlight off to prolong battery life
• The Hold function allows you to receive and display readings on the display with non-constant values of the measured parameters

Additional features of models 772 and 773:
• Measurement of 4-20 mA signals within the circuit
• Simultaneous measurement of low currents within a circuit with a 24 V power supply and test transducers
• Generation of 4-20 mA signals to test the inputs/outputs of control systems and I/P devices
• Low current ramp or low current output in 25% steps
• Automatic change of 4-20 mA signal for remote testing

Additional features of model 773:
• DC voltage measurement to check 24V supply or I/O voltage signals
• DC voltage generation. to test input devices accepting a 1-5V or 0-10V signal
• Measured low current signal output provides a constant low current signal corresponding to a 4 to 20 mA signal measured by a low current clamp.
• Allows low current signal recording to a separate recorder without breaking the current loop
• Low current output allows 4-20 mA current to be recorded to a data logging DMM or other device without breaking the current loop
• Low current I/O: Simultaneously measure low current signal with clamp and generate low current signal
• Apply a low current input to a device and measure its output in the 4-20 mA range for devices such as valves or low current isolators.
• Voltage ramp or voltage output in 25% steps
• Automatic voltage change for remote testing.