IS2-24-300GM, DC/AC inverter, sealed, 300W, input 24V, output 220V (car converter)
see technical documentation
The IS2-24-300 GM inverter (voltage converter) converts the DC battery voltage of 24 V into an AC sinusoidal voltage of 220 V and a frequency of 50 Hz.
IS2-24-300 GM has the possibility of a short-term double forcing of the power delivered to the load. This makes it possible to connect to the device devices that consume power during the switch-on phase that exceeds the rated power consumption of the device. For example, at the time of switching on, the power of the refrigerator exceeds its rated power up to five times.
The IS2-24-300 GM inverter allows operation with any type of batteries - lead, nickel-cadmium, lithium-ion, etc.
- Short circuit protection
When a short circuit occurs in the load circuit (connected equipment), the inverter will disconnect from the load and turn on periodically, monitoring for a fault. When the fault is cleared, the inverter will automatically return to the working state.
- Overload protection
When the power consumed by the load exceeds the rated power of the inverter
(300W) for more than 2s, the inverter will disconnect from the load and turn on intermittently while monitoring for overload. After the overload is removed, the inverter will automatically return to the working state.
- Overvoltage protection
If the supply voltage exceeds 31V, the inverter will shut down. Once the supply voltage is within the operating range, the inverter will automatically return to the operating state.
- Thermal protection (overheating protection)
If the temperature inside the device exceeds 70°C, the device will disconnect from the load. When the temperature inside the device drops, the inverter will automatically return to working condition.
- Battery protection against full discharge (from undervoltage)
When the input voltage drops below 21.5 V, the inverter will automatically turn off, thereby protecting the battery from deep discharge.
- Power saving mode ("sleep" mode)
In the event of no load, the inverter, if the toggle switch is set to "sleep", will go into low power mode (less than 30 mA). When a load exceeds 8W, the inverter will restore the working state.
What equipment can you connect to IS2-24-300 GM?
The IS2-24-300 GM inverter can be used in alternative energy systems (solar and wind power).
IS2-24-300 GM is a wide application inverter. Sinusoidal voltage allows you to connect to the inverter any equipment designed to operate on AC voltage 220 V and a frequency of 50 Hz:
- power tools (drills, saws, punchers, etc.)
- electric motors
- work on all types of loads is allowed: active, inductive, capacitive.
Products are certified!
|Input voltage, V||24|
|Output signal form||pure sine wave|